JF3-LT-2-5.5 KD16 Stainless A2

Üksikasjad
Applications: - Fixing of façade panels to 0.4-1.0 mm aluminum and steel substructures without screwing waste - Can be combined with LT sleeves for fixed and floating fixing points Features: - A2 stainless steel and hardened steel drill bit - Low cup shank (Ø16, TX25) - The attached part (TI) is normally pre-drilled Additional information: Benefits - Covers gaps and large pre-drilled holes - Also available in RAL colors - Flat screw head looks stylish - Fixing without screwing waste Note - Observe the relevant approvals and manufacturer's installation instructions for the façade panel Instructions for installing floating fixings to cladding panels: Stop tightening immediately when the screw head touches the surface of the panel, and relieve the load from the joint by loosening the screw a quarter turn. ETA-10/0200: Annex 143-145 Material: Stainless steel A2 Loe lähemalt

Dokumendid
Laadi Installation Instructions
Laadi Valikutabel

Kuvamisviis Nimekiri Laud

Selgitused

Toodete saadavusinfo tellimisel. Sisselogituna näete laoseisu meie erinevates kauplustes.

Registreeritud kasutajale kuvatud hinnad ei sisalda käibemaksu

70293225525 JF3-LT-2-5,5x30/KD16 EJOT EJOFAST Self-dr screw JF3

Saadaval kesklaost: Jah

Müügiüksus: Kappale

Drive: TX25

Length mm: 30

Drilling capacity mm: 0,4 + 1,0

Max. rotation speed (1/min): 1800

Diameter mm: 5,5

Material: A2

Base type: Ümarpea

Nendes kohtades laos:

Hulgimüügipartii 500 TK

Ostlemise Valikud